TM 9-2350-222-20-1-5
BULLDOZER BLADE ASSEMBLY REPLACEMENT (Sheet 3 of 11)
7.
locking bracket (E) as shown and use as lever to
support weight of inner tilt arms (F).
Using 15/16 inch socket, remove screw and
8.
lockwasher (G) and take off lock (H). Throw
lockwasher away.
NOTE
It may be necessary to use sledge
hammer and punch to remove
pins.
9.
Remove pin (J).
10.
Release leverage on crowbar and lower tilt
arms (F) to rest on rear of moldboard.
11.
Tilt moldboard face toward ground and lower to
maximum tilt position. Moldboard face will not
be fully on ground.
12.
Using 15/16 inch socket and 15/16 inch
wrench, remove screw and lockwasher (K) and
take off lock (L). Throw lockwasher away.
NOTE
Apply lift with hoist as necessary
to remove pins.
13.
Remove ram arm pivot pins (M).
NOTE
If hydraulic
system
is
not
operating, use jack to raise ram
arms.
14.
Raise ram arms to clear pushbeam wells. Strap
or tie ram arms in raised position.
TA141113
18-11
