TM 9-2350-222-20-1-5
DRIVER'S SEAT ADJUSTING ASSEMBLY REPAIR (Sheet 1 of 10)
PROCEDURE INDEX
PAGE
PROCEDURE
Disassembly
Cleaning and Inspection
Assembly
TOOLS: Slip joint pliers
1/2 in. combination box and open end wrench
9/16 in. combination box and open end wrenches (2 required)
Flat-tip screwdriver
1/8 in. drive pin punch
Hammer
Cold chisel 1/2 in.
3/8 in. drive pin punch
Vise
3/4 in. brass drive punch
File
SUPPLIES: Dry cleaning solvent (Item 54, Appendix D)
Rags (Item 65, Appendix D)
Cotter pins (112726) (3 required)
Retaining clip ('X' washer) (7404724) (2 required)
Pin (7404619)
Pin, grooved (MS35677-24) (2 required)
Bearing (7404617)
Seal (7404618)
Masking tape (Item 57, Appendix D)
Pencil
Lockwasher (MS35338-45)
Lockwashher (MS35338-44) (8 required)
Lockwasher (MS35338-46)
Remove adjusting assembly (page 17-21)
PRELIMINARY PROCEDURE:
Go on to Sheet 2
TA139224
