TM 9-2350-222-20-1-5
DRIVER'S PERISCOPE BOX ASSEMBLY REPAIR (Sheet 2 of 2)
ASSEMBLY:
1.
Place eyelet end of stud (A) into vise. Tighten
vise to secure stud (A).
2.
Position box (B) on stud (A) so that hollow end
of stud is inside box. Hold box (B) in this
position.
NOTE
Stud (A) cannot be completely
flattened with stud in one
position. After part of stud (A) has
been flattened, box (B) must be
moved in clockwise or
counterclockwise direction before
rest of stud can be flattened.
While one person holds box in position, other
person using hammer and punch, tap hollow
end of stud (A) until stud is flattened inside
box (B).
Remove box (B) with stud (A) installed from
vise.
Using brush, apply adhesive (Item 2,
installed.
install new pads (C), (D), (E), and (F) in same
location where old pads were installed.
Install strap (G) to box (B).
End of Task