TM 9-2350-222-20-1-5
HANDSET BOX BRACKET OR CABLE GUARD REPLACEMENT (LATE MODEL) (Sheet 1 of 3)
1-1/8 in. socket with 1/2 in. drive
TOOLS.
10 in. extension with 1/2 in. drive
9/16 in. socket with 1/2 in. drive
9/16 in. combination box and open end wrench (2 required)
Torque wrench with 1/2 in. drive (0-175 lb-ft) (0-237
5 in. extension with 1/2 in. drive
Nut, self-locking (MS51988-7) (5 required)
SUPPLIES:
PERSONNEL: Two
PRELIMINARY PROCEDURE:
NOTE
If replacing cable guard only, perform steps (1 through 3).
REMOVAL:
1.
Using 9/16 inch wrenches, and 9/16 inch socket remove three screws (A) and self-locking nute (B)
securing guard (C)to bracket (D). Throw self-locking nuts away.
2.
Using 9/16 inch wrench to hold nut (E), use 9/16 inch socket and remove two screws (F), washere (G),
and self-locking nuts (E) securing guard (C) to fender. Throw self-locking nuts away.
Remove guard (C) from fender.
3.
4.
Remove cable assembly (H) from bracket (D).
TA253651
Go on to Sheet 2
16-202.1