TM 9-2350-222-20-1-5
DRIVER'S HATCH SUPPORT BRACKET REPLACEMENT (Sheet 1 of 1)
TOOLS: 9/16 in. combination box and open end wrench
9/16 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
3 in. extension with 1/2 in. drive
SUPPLIES: Lockwasher (MS35338-65) (2 required)
REMOVAL:
1.
Using wrench on nut (A) and socket on bolts
(B), remove two nuts (A), two lockwashers (C),
four flat washers (D), and two bolts (B).
Throw lockwashers away.
NOTE
I f there are shims between
bracket (E) and plate (F), retain
them for installation.
2.
Remove bracket (E).
INSTALLATION:
Place washer (D) on each bolt (B).
1.
NOTE
If there were shims between
bracket (E) and plate (F), install
in position.
2.
Aline bracket (E) holes with plate (F) holes and insert two bolts (B).
3.
Place flat washer (D) and new lockwasher (C)
on each bolt (B) and secure with nut (A). Finger
tighten.
4.
Open driver's hatch cover (G).
Move bracket (E) on welded plate (F) until
5.
driver's hatch cover (G) rests securely in
bracket (E).
6.
Using wrench on nut and socket on bolts (B),
tighten two bolts.
End of Task
TA140736
