TM 9-2350-222-20-1-5
DRIVER'S HATCH SEAL REPLACEMENT (Sheet 2 of 2)
2.
Using dry cleaning solvent (Rem 54, Appendix D) and rags, remove remaining debris and dirt.
INSTALLATION:
Position new seal (A) into groove (B) to check
1.
for proper fit. If required, trim new seal (A) to
length.
2.
Using rags, clean new seal.
NOTE
Before applying adhesive to groove
(B), make sure solvent has dried.
3.
Using putty knife, apply thin coat of
adhesive (Item 2, Appendix D) to seal
mounting groove (B) and to seal (A) mating
surface.
Allow adhesive to become sticky, then press
4.
seal (A) into groove (B).
5.
Using rag moistened with dry cleaning solvent (Item 54, Appendix D), remove excess adhesive on
or near seal (A).
6.
Close driver's hatch (TM 9-2350-222-10).
End of Task
TA140735
