TM 9-2350-222-20- 1-5
M27 DRIVER'S PERISCOPE COVER ASSEMBLY REPAIR (Sheet 1 of 1)
TOOLS: Putty knife
Wire brush
SUPPLIES: Pad (8386867)
Adhesive (Item 3, Appendix D)
Watch
Remove cover assembly (page 16-83)
PRELIMINARY PROCEDURE:
DISASSEMBLY:
1.
Using putty knife, remove old pad (A) from
bottom of cover (B).
CLEANING AND INSPECTION:
1.
Using wire brush, clean old cement off cover
(B).
2.
Inspect cover (B) for cracks or damage. Replace
if defective.
ASSEMBLY:
1.
Apply adhesive. (Item 3, Appendix D) to bottom
of cover (B) and new pad (C).
2.
Place new pad (C) on cover (B) and press
together tightly.
3.
Remove air bubbles between cover (B) and pad
(C) by pressing blade of putty knife down and
pulling it across pad (C) from center to ends.
4.
Let adhesive cure for 30 minutes.
Install cover assembly (page 16-85).
5.
End of Task
