TM 9-2350-222-20-1-5
DRIVER'S HATCH TORSION BAR ANCHOR ADJUSTMENT (Sheet 3 of 6)
When screw (H) is removed in step
9, there will be a sudden backward
pull on hatch torque adapter of 206
not to let wrench slip from hands or
injury to personnel could result.
8.
Using hatch torque adapter (C), apply forward
pressure on anchor nut (J).
9.
Person in turret, using 3/4 inch wrench,
remove screw and lockwasher (H).
10.
Let hatch torque adapter (C) move to
rear approximately 1/8 of a turn or until
hole 2 is alined with hole in end housing (B).
11.
Person in turret, using 3/4 inch wrench, install
screw and lockwasher (H) in second hole.
12.
Reposition hatch torque adapter (C).
Apply forward pressure on anchor nut (J).
13.
Person in turret, using 3/4 inch wrench,
remove screw and lockwasher (H). Throw
lockwasher away.
14.
Let hatch torque adapter (C)move to
rear until all torque has been released
(approximately another 1/8 of a turn).
15.
Remove hatch torque adapter (C).
Go on to Sheet 4
Change 4
16-90
