TM 9-2350-222-20-1-5
DRIVER'S HATCH TORSION BAR ANCHOR ADJUSTMENT (Sheet 2 of 6)
3.
Assemble hatch torque adapter (C) by
placing 1 inch socket (D) and 7/8 inch
socket (E) on torque adapter.
4.
Place 8 inch extension (F) in 1 inch socket (D).
Place hinged handle (G) in extension (F).
5.
6.
Using 3/4 inch wrench, loosen screw and
lockwasher (H) from right end housing out
about 1/8 inch.
NOTE
Be sure hatch torque adapter (c)in step 7 is positioned as shown.
Proper positioning of torque adapter is necessary to prevent
jamming against ammunition racks.
NOTE
It may be necessary to use pipe
extension.
Position assembled hatch torque adapter
7.
(C) with 7/8 inch socket on anchor nut (J).
Go on to Sheet 3
16-89
Change 4
