TM 9-2350-222-20-1-5
SLIPRING BOX ACCESS COVER REPLACEMENT (Sheet 1 of 1)
TOOLS:
9/16 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
5 in. extension with 1/2 in. drive
Putty knife
SUPPLIES:
Gasket (8721804)
Dry cleaning solvent (Item 54, Appendix D)
Lockwasher (MS35338-65) (6 required)
Rags (Item 65, Appendix D)
Ashesive (Item 4, Appendix D)
REMOVAL:
NOTE
Slipring must be removed by organizational turret mechanic
before slipring box access cover can be removed.
1.
Using socket, reach through slipring cavity, remove six screws (A) and lockwashers (B) securing cover
(C) and gasket (D). Throw lockwashers (B) away.
2.
Remove cover (C) and gasket (D). Throw gasket (D) away.
3.
Using putty knife, rags, and dry cleaning solvent (Item 54, Appendix D) remove any old gasket
material from cover and mating surface of hull.
INSTALLATION:
1.
Apply adhesive (Item 4, Appendix D) to new gasket (D) and position gasket on cover (C).
2.
Place cover (C) and new gasket (D) in position.
8.
Using socket, install six screws (A) and new lockwashers (B).
NOTE
Slipring must be replaced by organizational turret mechanic
after slipring box access cover is installed.
End of Task
TA253558
