TM 9-2350-222-20-1-5
BULKHEAD FLOOR ACCESS COVER REPLACEMENT (Sheet 1 of 1)
TOOLS:
8 in. cross-tip screwdriver
6 in. cross-tip offset screwdriver
Putty knife
SUPPLIES:
Gasket (10864181)
REFERENCE: TM 9-2350-222-10
REMOVAL:
1.
Open turret platform access door (A) (TM 9-2350-222-10).
Traverse turret to expose desired bulkhead
2.
floor access cover (B) (TM 9-2350-222-10).
NOTE
It may be necessary to use
p e n e t r a t i n g oil (Item 42,
be done.
NOTE
It may be necessary to use
offset srewdriver to remove
screws located under turret
floor.
3.
Using screwdriver, remove 14 screws (C)
securing access cover (D) to vehicle.
NOTE
If screws will not come out,
notify support maintenance
for turret removal.
4.
Remove cover (D) and gasket (E). Throw
gasket (E) away.
5.
Using putty knife, rags, and dry cleaning
old gasket material from cover and mating
surface on hull.
INSTALLATION:
1.
new gasket (E) and position gasket on cover (D).
2.
Place new gasket (E) and cover (D) in position.
Using screwdriver, install 14 screws (C).
3.
4.
Close turret platform access cover (A) (TM 9-2350-222-10).
TA253559
End of Task