TM 9-2350-222-20-1-4
STEERING CONTROL INTERMEDIATE LINK ASSEMBLY REPLACEMENT (Sheet 2 of 2)
INSPECTION:
1.
Inspect bearing of link assembly (B) (TM 9-214).
2.
Replace bearing if required.
INSTALLATION:
1.
Position washer (A) and link (B) on stud (C).
2.
Position washers (D) and (E) on stud (C).
3.
Using wrench, install nut (F).
4.
Using pliers, install new cotter pin (G).
5.
Position two rod ends (H) in link assembly (B).
6.
Install two bolts (J) through link assembly (B)
and rod ends (H).
7.
Using torque wrench and socket, tighten bolts
(J) to 15-20 lb-ft (20-27 N-m).
End of Task
15-23
