TM 9-2350-222-20-1-4
FRONT STEERING CONTROL CONNECTING ROD REPLACEMENT (Sheet 3 of 3)
3.
Check if steering control (E) is centered. If steering control is not centered, proceed to step 4. If
centered, proceed to step (7).
4.
Install locating pin (F) to lock link (B).
5.
Using wrench, remove one screw (D) and remove rod assembly (A) from link. Adjust rod end bearing
(G) until steering control (E) is centered.
6.
Install rod assembly (A) to link and install screw (D) and remove locating pin (F).
7.
8.
Using wrench, tighten nuts (H) up against rod end bearings (G).
9.
Using 9/16 inch crowfoot and torque wrench, tighten nuts (H) 15-20 lb-ft (20-27 N. m).
End of Task
TA253522
Change 1 15-21
