TM 9-2350-222-20-1-4
FRONT STEERING CONTROL CONNECTING ROD REPLACEMENT (Sheet 2 of 3)
INSPECTION AND REPAIR:
Inspect rod (A), rod end bearings (B), and nut (C) for damage and wear. Replace as required.
1.
NOTE
If rod (A) or rod end bearing (B) must be
replaced proceed to step 2. If not
proceed to installation.
Using two wrenches, remove rod end bearings (B) and nuts (C) from rod (A). Replace parts as required.
2.
Install nuts (C) onto rod (A) until they bottom.
3.
Install rod end bearings (B) onto rod (A) a minimum of four turns.
4.
INSTALLATION:
Position rod assembly (A) to links (B and C).
1.
Using wrench, install screws (D) to secure
2.
rod assembly to links.
--
TA253521
15-20.2 Change 1
