TM 9-2350-222-20-1-4
STEERING LEVER ASSEMBLY REPAIR (Sheet 3 of 5)
5.
Using 1/8 inch punch and hammer, drive pin
and link assembly (H) upward until clear of
support (J).
6.
Remove and discard pin and link assembly
(H) and washer (K).
7.
Using 1/8 inch punch and hammer, drive out
top bearing (L) and bottom bearing (M) from
support (J).
8.
Retain removed bearings (L and M) to be
used as an aid during installation.
ASSEMBLY:
1.
Position new bearings (A) and (B) to support (C).
2.
Using hammer and old bearings, drive bearings
(A) and (B) into support (C). Be sure bearings
are flush with support surfaces.
Go on to Sheet 4
Change 5 15-24.3
