TM 9-2350-222-20-1-4
STEERING CONTROL HANDLE AND SLEEVE MOUNT REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
Position steering handle (A) in mount (B).
1.
2.
Using retaining ring pliers, install retaining ring (C) in retaining ring groove of handle (A).
Line up holes in lever (D) and handle (A).
3.
Install pin (E) through holes in lever (D) and handle (A).
4.
Using slip joint pliers, install new cotter pin (F) through pin (E).
5.
Take assembled handle and mount to driver's station and position mount (B) on mount inside of
6.
vehicle.
Using two wrenches, install four screws (G), new lockwashers (H), and nuts (J).
7.
8.
Connect front steering control rod assembly (page 15-19, steps 1, 3, and 4).
End of Task
TA253527
