TM 9-2350-222-20-1-4
ROADWHEEL ARM REPAIR (Sheet 9 of 9)
Apply grease to bearing spacer (E) and bearing washer (F).
15.
16.
Install bearing spacer (E) onto spindle up against outboard bearing (C),.
17. Repeat step 14 to install inboard bearings (D).
.8. Install key washer (G) on spindle of arm so that inside tab fits into groove
NOTE
Make sure outer tabs of key washer are pointing towards nut (H).
19.
Screw nut (H) onto threaded end of spindle.
20.
Using spanner wrench (Item 29.2, Chapter 3,
Section I), tighten nut (H) until parts on spindle
cannot be turned by hand.
21.
Back off nut (H) just enough so parts can be
turned by hand through one complete turn on
spindle.
Using pliers, bend tab on key washer (G) into
22.
alining slot on nut (H).
23. Install roadwheel arm (page 14-6).
End of Task
Change 5
14-1 4.3/( 14-14.4 blank)
