ROADWHEEL ARM REPAIR (Sheet 6 of 9)
If deflector (A) was removed, care-
fully position new deflector in place
over upper spindle against machined
ridge in arm (B). Assure base of U-shaped
deflector (A) is towards arm and open
end towards threaded end of spindle.
Tap deflector (A) lightly with hammer to
assure it seats fully against arm (B).
Position shock absorber bearing (C) on arm.
Install replacer (Item 24, Chapter 3, Sec-
tion I) over bearing (C) and arm (B).
Turn replacer nut until bearing (C) is
centered in arm (B). Remove replacer.
Stake bearing (C) to arm (B) at three
equally spaced locations on each side
of bearing (C).
If replacing bearing for mechanical
track adjusting link, perform steps 4
and 5. If replacing bearing for grease
actuated track adjusting link, peform
steps 6 and 7.
Position bearing (D) on arm (B). Install
bearing driver (Item 29.1, Chapter 3,
Section I) over bearing (D). Turn nut of
bearing driver until bearing (D) is centered
in arm (B). Remove bearing driver.
Stake bearing (D) to arm (B) at three
equally spaced locations on each side of
bearing (D). Go to step 8.
Go on to Sheet 7