TM 9-2350-222-20-1-4
HUB ASSEMBLY REPLACEMENT (Sheet 4 of 7)
Inspect bearings and cups for damage. Replace
4.
as necessary.
Check seal assembly for rust, missing rivets, or
5.
other damage. Replace seal as required.
Inspect all nuts, washers, and screws for
6.
wear and damaged threads.
Inspect spacer on spindle for scratches, nicks,
7.
or dents. If damaged, notify support
maintenance.
ASSEMBLY:
Grease (Item 36, Appendix D) both bearing
1.
cups. Position remover-replacer tool (Item 16,
Chapter 3, Section I) to inner cup (A) in hub
(B).
Using hammer, tap remover-replacer to seat
2.
inner cup (A) into place in hub (B).
Using other remover-replacer tool (Item 15,
3.
Chapter 3, Section I) with hammer, repeat steps
1 and 2 to seat outer cup (C) in hub (B).
Go on to Sheet 5
TA141300
14-18 Change 1
