TM 9-2350-222-20-1-4
ROADWHEEL ARM REPAIR (Sheet 8 of 9)
8.
Coat outer edge of seal with grease.
9.
Position seal (A) into retainer with front of seal
facing upward.
Using replacer and handle, tap handle with
10.
hammer to install seal (A).
Install oil seal replacer (Item 20, Chapter 3,
11.
Section I) to face with spacer on upper
spindle of arm.
Position retainer (B) onto upper spindle
12.
13.
Make sure seal in retainer (B) fits into open
end of deflector on roadwheel arm.
NOTE
Keep bearing halves together as a set when installing
outboard and inboard bearing (C) and (D).
14. Coat inner and outer races of outboard bearings (C) with grease. Install inner race on
spindle. Install outer race over it.
Go on to Sheet 9
Change 5
14-14.2
