TM 9-2350-222-20-1-4
PARKING BRAKE CONTROL ASSEMBLY AND LINKAGE REPLACEMENT
(DRIVER'S STATION) (Sheet 5 of 10)
16.
From engine compartment, using 9/16 inch
wrench to hold nut (AF), use adjustable wrench
and remove rod end connector (AG) from
control assembly (Q,).
17.
Using 9/16 inch wrench, remove nut (AF) from
control assembly (Q).
18. Using 15/ 16 inch wrench, remove brake control nut (AH) and preformed packing (AJ) from control
assembly (Q). Throw packing (AJ) away. Use adjustable wrench to hold support bracket (AK).
19. Using 15/16 inch wrench, remove nut (AL) and lockwasher (AM) from control assembly (Q).
Remove support bracket (AK) and lockwasher (AN) from control assembly (Q). Throw lockwashers
away.
20. Using 15/16 inch wrench, remove nut (AP)
from control assembly (Q).
21. Using 7/16 inch wrench, remove capscrew
(AQ), lockwasher (AR), and clamp (AS)
securing control assembly (Q) to hull. Throw
lockwasher away.
Go on to Sheet 6
TA140414
13-109