TM 9-2350-222-20-1-4
PARKING BRAKE CONTROL ASSEMBLY AND LINKAGE REPLACEMENT
(DRIVER'S STATION) (Sheet 8 of 10)
11. Locate lever (K), pin (L), rod end (M), nut (N),
and new spring pin (P). Using 7/16 inch
wrench, install nut (N) onto rod end connector
(M).
12. Using pliers to hold pin (L), use adjustable
wrench to install rod end connector onto pin
(L).
13. Position split end of lever (K) over rod end
connector (M). Using pliers, install new
spring pin (P) through level (K) and rod end
connector (M).
14. Position assembled lever (K) so pin (L) fits
into hole in base (Q) at (R) (hidden).
15. Position lever (K) onto base (Q) and secure with pin (S). Using pliers and hammer, install new
spring pin (T) into pin (S).
16. Using pliers, install straight pin (U) through straight head pin clevis (V) and secure Pin (U) with
new cotter pin (W).
Go on to Sheet 9
TA140417
13-112