TM 9-2350-222-20-1-4
PARKING BRAKE CONTROL ASSEMBLY AND LINKAGE REPLACEMENT
(DRIVER'S STATION) (Sheet 3 of 10)
4.
Remove lever (C), spring pin (K), straight pin
(L), rod end connector (M), and nut (N) as a
unit.
5.
Using 7/16 inch wrench to hold nut (N), use
pliers and remove straight pin (L) from rod end
connector (M). Remove nut (N) from rod end
connector (M).
6.
Using hammer and punch, remove spring pin
(K) from lever (C) and rod end connector (M).
Throw pin (K) away.
7.
Using 9/16 inch wrench to hold nut (P), use 8
inch adjustable wrench to remove clevis (D)
from control assembly (Q).
8.
Using 9/16 inch wrench, remove nut (P) from
control assembly (Q).
9.
Using 15/16 inch wrench, remove nut (R)
and lockwasher (S) from control assembly (Q).
Throw lockwasher away.
10. Pull control assembly (Q) through support bracket (T) and use 15/16 inch wrench to remove nut
(U) and lockwasher (V) from control assembly (Q). Hold control assembly (Q) with adjustable
wrench. Throw lockwasher away.
Go on to Sheet 4
TA140412
13-107