TM 9-2350-222-20-1-4
PARKING BRAKE CONTROL ASSEMBLY AND LINKAGE REPLACEMENT
(DRIVER'S STATION) (Sheet 2 of 10)
NOTE
Although the parking brake control assembly on the newer
m o d e l vehicles is a two-piece cable and the older model
vehicles (not yet modified) have a one-piece cable, both are
removed exactly the same way.
However, i f only the
transmission end of the two-piece cable needs replacing, go to
steps 16 thru 21 and step 25. If complete two-piece cable is
to be removed and replaced, use steps 1 thru 25.
REMOVAL:
1.
In driver's station, using pliers, remove cotter pin (A) and straighthead pin (B) securing lever (C) to
clevis (D). Throw cotter pin (A) away,
2.
Using pliers, remove cotter pin (E) and
straighthead pin (F) securing lever (C) to base
(G). Throw cotter pin (E) away.
3.
Using hammer and punch, remove spring pin
(H) from straight pin (J) and remove straight
pin (J) from lever (C) and base (G). Throw
spring pin (H) away.
Go on to Sheet 3
TA140411
13-106
