TM
9-2350-222-20-1-4
RING (QUICK -DISCONNECT) ASSEMBLY REPLACEMENT (Sheet 2 of 3)
NOTE
Do the following procedure for both
sides of powerplant.
REMOVAL:
Rotate ring (quick-disconnect)
1.
assembly (A) to a workable
position.
Using wire cutter, cut
2.
lockwire (B).
NOTE
When removing screw (C), hold onto
quick-disconnect ring (A) or it will
snap open and fall down into engine
compartment.
Using socket and extension,
3.
remove screw (C).
UNIVERSAL-JOINT
,
4. Remove ring (quick-disconnect) assembly
(A) from universal joint (D).
Go on to Sheet 3
12-8.2 Change 4
