TM 9-2350-222-20-1-4
SHIFT LINKAGE ADJUSTMENT (Sheet 6 of 20)
28.
Using 9/16 inch wrench, adjust shifting rod
bearing end (Z) by turning clockwise or
counterclockwise until screw (Y) drops freely
through clevis (AA) and shifting rod bearing
end (Z).
29.
Using 9/16 inch wrench, install screw (Y)
through clevis (AA) and shifting rod bearing
end (Z).
Using crowfoot and torque wrenches, tighten
30.
jamnut (R) to 15-20 lb-ft (20-27 N.m).
Remove locating pin from alinement hole (P).
31.
Using 9/16 inch socket and torque wrench,
32.
tighten screw (Y) to 15-20 lb-ft (20-27 N.m)
and go to step 43.
Go on to Sheet i'
TA253366
Change 1 11-7
