TM 9-2350-222-20-1-3
EXHAUST PIPE (RIGHT SIDE) REPLACEMENT (Sheet 3 of 4)
INSTALLATION:
Position packing (A) and clamp (E) onto pipe (C) and, using flat-tip screwdriver, tighten screw on
clamp (B) securing packing to pipe (C).
2.
Check insulation halves (D) and all attaching hardware for damage. Replace if necessary.
3.
Position insulation halves (D) onto exhaust
pipe (C).
4.
Using 5/16 inch wrench and cross-tip screwdriver, install 14 screws (E), each with two flat washers
(F), one new lockwasher (G), and one nut (H) to hold insulation halves (D) to exhaust pipe (C).
5.
Position new gasket (J) onto turbosupercharger
housing (K).
Position exhaust pipe (C) with installed
6.
insulation halves (D) onto turbosupercharger
housing (K). Make sure exhaust port (L) is
pointing up.
7.
Using 9/16 inch socket and 9/16 inch wrench,
install six new self-locking nuts (M) securing
exhaust pipe to housing.
Go on to Sheet 4
TA140465
8-11
