TM 9-2350-222-20-1-3
CAP ASSEMBLY REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
1.
If bracket (A) was removed, position new bracket (A) onto engine. Using 1/2 inch socket,
install two screws (B) to secure bracket (A).
2.
Position new gasket (C) and cap assembly
(D) to intermediate tube assembly (E).
3.
Using 7/16 inch or 1/2 inch socket, install
but do not tighten screw (F) and new lock-
washer (G) to secure cap assembly (D).
4.
Using 1/2 inch or 7/16 inch socket, install
screw (H) and new lockwasher (J) to secure
cap assembly (D). Tighten two screws (F)
and (H).
5.
Install clamp (K) onto cap assembly (D).
6.
Using 1/2 inch socket and wrench, install
screw and new nut (L) to secure clamp (K)
to bracket (A).
7.
Coat ends of hoses (M and N) with silicone
compound (Item 32, Appendix D).
8.
Position hoses (M and N), tube (P), and
clamps (Q), removed as a unit, to mani-
fold (R) and cap assembly (D).
Using screwdriver, tighten clamps (G) to
9.
secure hoses (M and N) to manifold (R)
and cap assembly (D).
10.
Close top deck grille doors (TM 9-2350-
222-10).
End of Task
TA249101
8-16
Change 2
