TM9-2350-222-20-1-3
FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE)
(Sheet 5 of 8)
INSTALLATION:
1.
Position three cushioned clamps into sensor
leads from replaced fuel-water separator control
assembly.
2.
Position fuel-water separator control assembly
(A) onto mounting plate.
3.
Using 5/16 inch socket with extension, install
three screws and washers(B).
4.
Using 5/16 inch wrench, install screw and
cushioned clamp (C) holding solenoid valve
electrical lead (D) to fuel-water separator
control assembly (A).
Go on to Sheet 6
TA148897
7-318
