TM9-2350-222-20-1-3
FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE)
(Sheet 3 of 8)
8.
Using 1/2 inch socket and extension, remove
9.
Using 1/2 inch socket and extension, loosen
capscrew (F) to provide movement to fuel-
water separator filter.
NOTE
If adapters turn while removing
sensors, use 1/2 inch wrench to
hold them in place.
10. Using 9/16 inch wrench, remove upper sensor
(G) from fuel-water separator filter.
NOTE
It may be necessary to use
h a m m e r and punch to unseat
sensors (G) and (H) by tapping
upward on the edge of the sensor
retaining nut.
11. Using 9/16 inch wrench, remove lower sensor (H) from fuel-water separator filter.
Go on to Sheet 4
TA148895
7-316