TM9-2350-222-20-1-3
FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE)
(Sheet 4 of 8)
12. Using screwdriver, remove two screws and two
cushioned clamps (J) and mounting plate (K) at
right side and above fuel-water separator
control assembly (L).
NOTE
It may be necessary to use pliers
to start removal of connectors in
steps 13 and 14.
13. Manually disconnect engine electrical harness
connector (M) from fuel-water separator control
assembly (L).
14. Manually disconnect solenoid valve electrical
lead (N) from fuel-water separator control
assembly (L).
15.
Using 5/16 inch wrench, remove screw and
cushioned clamp (P) holding solenoid valve
electrical lead (N) to fuel-water separator
control assembly (L).
16.
Using 5/16 inch wrench, remove three
remaining screws and washers (Q) holding
fuel- water separator control assembly (L) to
mounting plate. Remove control assembly.
Go on to Sheet 5
TA148896
7-317
