TM9-2350-222-20-1-3
FUEL-WATER SEPARATOR DRAIN LINES REPLACEMENT (2D ENGlNE)(Sheet 1 of 6)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Installation
TOOLS: 11/16 in. combination box and open end wrench (2 required)
9/16 in. combination box and open end wrench
7/16 in. combination box and open end wrench
5/8 in. combination box and open end wrench
6 in. adjustable wrench
Vise
Slip joint pliers
SUPPLIES: Rags (Item 65, Appendix D)
Drip pan
Lockwasher (MS35337-28)
PRELIMINARY PROCEDURE:
NOTE
These procedures are given for replacement of 2D engine
fuel-water separator drain lines. Only perform those steps
necessary to replace the defective part.
Go on to Sheet 2
TA148887
7-308