TM9-2350-222-20-1-3
FUEL-WATER SEPARATOR DRAIN LINES REPLACEMENT (2D ENGINE) (Sheet 3 of 6)
6.
Using 9/16 inch wrench, remove nut (D)
securing clamp (E).
Remove clamp (E) from hose assembly (F).
7.
Using 9/16 inch wrench, disconnect hose
8.
assembly (F) from elbow (G).
Using 11/16 inch wrench to hold adapter (H),
9.
use 9/16 inch wrench and disconnect hose
assembly (F) from adapter (H).
Remove hose assembly (F).
10.
Using 9/16 inch wrench, disconnect hose
11.
assembly (J) from tee (K).
Using 5/8 inch wrench to hold tee (K), use
12.
adjustable wrench and remove drain valve (A
Using 11/16 inch wrench to hold adapter (H),
13.
use 11/ 16 inch wrench and remove nut and
lockwasher (L). Tee (K) and adapter (H) will
fall free when nut (L) is removed. Throw
lockwasher away.
Install tee (K) into vise, and, using 11/ 16 inch wrench, remove adapter (H) from tee (K).
14.
Go on to Sheet 4
TA148889
7-310
