TM9-2350-222-20-1-3
REPLACEMENT (2D ENGINE) (Sheet 1 of 1)
TOOLS: 5/16 in. combination box and open end wrench
Slip joint pliers
PRELIMINARY PROCEDURE:
REMOVAL:
Using wrench, remove screw and washer (A)
1.
from clamp (B). Remove clamp from harness
(c).
Using pliers, disconnect harness (C) from
2.
control assembly (D) and drain solenoid (E), and
INSTALLATION:
1.
Connect harness (C) to control assembly (D) and drain solenoid (E) as shown.
2.
Using pliers, tighten connectors on ends of harness (C).
Position clamp (B) around harness (C) as shown, being sure to place clamp around leads at control
3.
assembly.
4.
Using wrench, install screw and washer (A) through clamp (B) into control assembly mount.
5.
End of Task
TA1488883
7-304
