TM9-2350-222-20-1-3
FUEL-WATER SEPARATOR FUEL FILTER OUTLET HOSE ASSEMBLY REPLACEMENT
(Sheet 2 of 3)
REMOVAL:
1.
Using 9/16 inch wrench, remove self-locking
nut (A) and hose clamp (B) from hose assembly
(c).
2.
Using 7/8 inch wrench, remove hose assembly
(C) from bulkhead elbow (D).
3.
Using 7/8 inch wrench, remove hose assembly
(C) from elbow (E) of water separator fuel filter
(F).
CLEANING AND INSPECTION:
1.
Using clean rags (Item 65, Appendix D) and
dry cleaning solvent (Item 54, Appendix D),
clean hose clamp and self-locking nut
thoroughly,
2.
Inspect hose clamp and self-locking nut for
wear or damage.
3.
Inspect bulkhead elbow and water separator
fuel filter outlet elbow for stripped threads.
4.
Replace defective parts as required.
Go on to Sheet 3
7-297
