TM9-2350-222-20-1-3
FUEL INLET FLUID PRESSURE FILTER REPAIR (Sheet 2 of 2)
CLEANING AND INSPECTION:
WARNING
Compressed air used for cleaning purposes will not exceed 30
psi. Use only with effective chip guarding and personal
protective equipment (goggles/shield, gloves, etc.).
Inspect for broken, cracked components and for general serviceability. Replace as necessary.
1.
2.
Clean filter bowl, element, and spring with dry cleaning solvent (Item 54, Appendix D).
Blow low-pressure, compressed air through filter element to remove dirt particles. Replace
3.
element if damaged.
ASSEMBLY:
1.
Place new preformed packing (A) in position on filter bowl (B).
Place filter element and spring (C) in filter head
2.
3.
Place filter bowl (B) and filter head (D) together.
4.
Using wrench, screw together filter bowl (B)
and filter head (D).
5.
6.
Start engine and check for leaks (TM
9-2350-222-10).
End of Task
TA149077
7-295