TM9-2350-222-20-1-3
FUEL INLET FLUID PRESSURE FILTER REPLACEMENT (Sheet1of3)
TOOLS: 1/2in. combination box and open end wrench
9/16 in. combination box and open end wrench
Cross-tip screwdriver
6 in. adjustable wrench
SUPPLIES: Sealing compound (Item 23, Appendix D)
Rags (Item 65, Appendix D)
Lockwasher (MS35338-43) (2 required)
REFERENCE: TM 9-2350-222-10
REMOVAL:
Place rags (Item 65, Appendix D) under filter
1.
(C) to soak up any fuel that may be in lines.
2.
Place 9/16 inch wrench on connector (A).
3.
Place 1/2 inch wrench on adapter (B).
NOTE
Fuel lines will be loosened all of
be
way,
but
the
cannot
disconnected from filter (C) until
later.
While holding adapter (B), loosen connector (A).
4.
Go on to Sheet 2
TA149073
7-291