TEST - TM-9-2350-222-20-1-30474

TM-9-2350-222-20-1-3 Combat Engineer Vehicle Full-Tracked M728 2350-00-795-1797 (Hull) Manual
Page Navigation
441

Connect engine for powerplant ground hop

Using 7/16 inch wrench, open bleed cap (A).

Set FUEL PUMPS switch to ON (TM

9-2350-222-10).

Set MASTER BATTERY switch to ON (TM

9-2350-222-10). Watch bleed cap (A) of fuel-

water separator filter (B) for air release

(bubbles).

Set MASTER BATTERY switch to OFF (TM

9-2350-222-10). After about one minute, repeat

step 4. When constant fuel flow is seen, go to

step 7.

NOTE

It may be necessary to perform

steps 4 and 5 several times until

constant fuel flow (no bubbles)

from bleed cap (A) is observed.

Check for leaks and tighten or replace components as necessary.

Using 7/16 inch wrench, tighten fuel-water separator bleed cap (A) until snug.

Set FUEL PUMPS switch to OFF (TM 9-2350-222-10),

Set MASTER BATTERY switch to OFF (TM 9-2350-222-10).

10.

Disconnect engine from powerplant ground hop (page 5-62).

11.

12.

Install 2A powerplant (page 5-14) or 2D powerplant (page 5-37).

End of Task

All data on pages 7-284 thru 7-287 deleted.

Change 4

7-283

Privacy Statement
Press Release
Contact