TM9-2360-222-20-1-3
FUEL-WATER SEPARATOR FLUID PRESSURE FILTER REPLACEMENT (Sheet 6 of 7)
5.
Using socket, install two capscrews, new
lockwashers, and flat washers (E).
(2A engine). Install capscrew, new
6.
lockwasher, and flat washer (G) onto
fuel-water separator filter (H).
Position clamp (F) around sensor wires (C)
7.
and (D) and, using socket, install capscrew,
new lockwasher, flat washer (G), and clamp
(F) onto fuel-water separator filter (H).
8.
Using socket, tighten capscrew (B).
VIEW FROM BOTTOM OF FILTER
(SHOWN REMOVED FROM ENGINE
FOR CLARITY)
9.
Using 9/16 inch wrench, install condensate
drain line (J) to elbow (K).
10.
Remove plastic barrier material and tape from
openings of fuel inlet line (L) and elbow (M).
Using 7/8 inch wrench, install fuel line (L) to
11.
elbow (M).
12.
Remove plastic barrier material and tape from
openings of fuel outlet line (N) and elbow (P).
13.
Using 7/8 inch wrench, install outlet line (N) to
elbow (P).
Go on to Sheet 7
TA149064
7-282
