TM 9-2350-222-20-1-3
POWERPLANT REPLACEMENT (2D ENGINE) (Sheet 6 of 23)
NOTE
One angle bracket (U) is located on each side
at rear of vehicle.
15. Using 9/16 inch socket with 2 inch exten-
sion. remove three screws (V), lockwashers
(W), and washers (X) securing each angle
bracket (U). Throw lockwashers away.
16.
Lift up rear corner of bracket (U) to remove
it.
NOTE
If you have an early model
vehicle, go on to step 17. If you
have a late model vehicle, do
s t e p s 16.1 thru 16.7 and skip
steps 17 thru 20.
Go on to Sheet 6.1
TA249053
5-30
Change 2
