TM 9-2350-222-20-1-3
POWERPLANT REPLACEMENT (2D ENGINE) (Sheet 5 of 23)
10. On early model, reach through engine access
cover opening and use 7/16 inch wrench to
remove bolt (M) holding accelerator linkage
clevis (N) to rod end (P).
10.1. On late model, reach through engine access
cover opening and use 7/16 inch wrench to
remove two bolts (P. 1) securing manual fuel
shutoff clevis (P.2) and accelerator linkage
lever (P.3) to rod ends (P.4).
10.2. On late model, separate accelerator linkage
lever (P.3) and fuel shutoff clevis (P.2) from
two rod ends (P.4).
11. Using spanner wrench, remove four electrical
harness connectors (Q).
12. Using light rope or heavy masking tape,
tie electrical connectors out of way of
Go on to Sheet 5.1
TA249051
Change 2
5-28.1/(5-28.2 blank)
