Remote Throttle (12)—Indicates that the engine
speed is being controlled by the remote throttle
switch.
NOTE: The blackout switch must be in the STOP
LIGHT or SERVICE DRIVE position for remote throttle
indicator (12) to function.
Hydraulic Oil Temperature (13)—Indicates that the
hydraulic oil temperature is too high. If this light comes
on during operation, slow the machine until the light
goes off. If the light continues to illuminate during
normal operating conditions, have the cause of the
hydraulic system overheating investigated and
corrected.
NOTE: The blackout switch must be in the STOP
LIGHT or SERVICE DRIVE position for hydraulic oil
temperature indicator (13) to function.
Indicator Check Function
When the engine is running, the start position of the
engine start switch (1) will perform an indicator check
function.
NOTE: The ECM will disengage the starter at 600
rpm. Holding the starter engaged after the engine has
started will not damage the starter.
When engine start switch (1) is held in the START
position, the following indicators will turn on to test for
failed indicator bulbs. Have Unit Maintenance
personnel replace any indicator bulbs that do not turn
on during the check.
NOTE: The blackout light switch must be in the STOP
LIGHT or SERVICE DRIVE position for the indicators to
turn on in the indicator check function.
1
12
13
27
Operation Section
Monitoring Systems and Cab Features
TM5-2430-200-10
