24
TM5-2430-200-10
Operation Section
Monitoring Systems and Cab Features
Low Brake Pressure Indicator (43)
Blade Down Indicator (50)
Engine Oil Pressure Indicator (44)
Hydraulic Oil Temperature Indicator (54)
Start-Aid Indicator (55)
Check Engine Indicator (51)
Crank-Without-Inject Indicator (45)
Kneeling Mode Indicator (46)
Winch Indicator (47)
Self-Deploy Indicator (48, dim level)
Remote Throttle Indicator (53)
SERVICE DRIVE (25), PARK (29)—Move lever (A)
into the SERVICE DRIVE position and lever (C) into the
PARK position to enable the following lamps to
function:
Right and Left Brake Lamps (40)
Interior Light (56)
Right and Left Rear Working Lamps (19)
Right and Left Center Work Lamps (18)
Right and Left Front Work Lamps (18)
Right and Left Turn Lamps (42, on panel)
Rear Right and Left Turn Signal Lamps (37)
Front Right and Left Turn Signal Lamps (33)
Right and Left Tail Lamps (39)
Right and Left Front Marker Lamps (32)
All Panel and Gauge Lamps (52, dim level)
Tension Fail Indicator (49)
Low Brake Pressure Indicator (43)
Blade Down Indicator (50)
Engine Oil Pressure Indicator (44)
Hydraulic Oil Temperature Indicator (54)
Start-Aid Indicator (55)
Check Engine Indicator (51)
Crank-Without-Inject Indicator (45)
Kneeling Mode Indicator (46)
Winch Indicator (47)
Self-Deploy Indicator (48, dim level)
Gauges
Engine Oil Pressure (1)—Indicates the
engine oil pressure is kPa (psi)
NOTE: The normal engine oil pressure range should
Be between 250 and 450 kPA (30 and 70 psi) when
The engine is running at full speed with SAE 15W40 oil
at operating temperature.
Engine Coolant Temperature (2)—Indicates
the temperature of the engine coolant in
degrees celsius and degrees fahrenheit. If
the engine coolant temperature increases above 110°C
(230°F), stop operation of the machine and allow the
engine to idle for a few minutes. If the coolant
temperature will not return to 110°C (230°F) or less
during normal working conditions, stop the machine
and investigate the cause of engine overheating.
Transmission Oil Temperature (3)—Indicates
the temperature of the transmission system
oil in °C (°F). If the transmission system oil
temperature increases above 110°C (230°F),
stop operation of the machine and allow it to idle for a
few minutes. If the transmission oil temperature will not
return to 110°C (230°F) or less during normal working
conditions, stop the machine and investigate the
cause of the transmission system overheating.
Engine RPM (4)—Indicates the engine speed
in revolutions (Xl00) per minute.
The service Hour Meter is located on the engine
rpm gauge.
Speedometer (5)—Indicates machine ground speed in
miles-per-hour and kilometers-per-hour.
Voltmeter (6)—Indicates the electrical
system voltage at different operating
conditions.
