26
TM5-2430-200-10
Operation Section
Monitoring Systems and Cab Features
Blade Down (3)—Indicates that the blade is
not in the full up position when the machine
is in SELF-DEPLOY mode.
NOTE: If the blackout switch is in the STOP LIGHT or
SERVICE DRIVE position, the blade down alarm will
sound when blade down indicator (3) is illuminated.
Start-Aid (4)—Indicates the operation of the
start-aid system (intake air heater or ether
injection).
NOTE: The blackout switch must be in the STOP
LIGHT or SERVICE DRIVE position for start-aid
indicator (4) to function.
Engine Oil Pressure (5)—Indicates that
there is not enough engine oil pressure. The
oil pressure indicator illuminates when the
oil pressure is 35 ± 21 kPa (5 ± 3 psi)
NOTICE
Do not continue to operate the machine if the engine
oil pressure indicator is on, or if the engine oil pressure
gauge indicates an engine oil pressure of less than 50
kPa (10 psi), 15 seconds after starting the engine. Stop
the machine immediately and inform Unit Maintenance
of the problem. Do not operate the machine until the
cause of the low engine oil pressure has been
corrected.
Check Engine (6)—Indicates the presence of
a fault code in the engine electronic control
module. Refer to “Troubleshooting, Engine
Diagnostic Codes” in this manual for information on
diagnostic codes.
NOTE: The blackout switch must be in the stop
LIGHT or SERVICE DRIVE position for check engine
Indicator (6) to function.
Crank-Without-Inject (7)—Indicates the fuel delivery
System has been disabled, to allow the engine to be
Turned over without starting. This operational mode is
Used only by service personnel to repair the engine.
NOTE: the blackout switch must be in the STOP
LIGHT or SERVICE DRIVE position for crane-without-
Inject indicator (7) to function.
Turn signal (8)—Indicates the direction of the turn
signal.
NOTE: The blackout switch must be in the STOP
LIGHT or SERVICE DRIVE position for turn signal
Indicators (8) to function.
Kneeling (9)—Indicates that the machine is fully
Lowered into the kneeling mode.
NOTE: the blackout switch must be in the STOP
LIGHT or SERVICE DRIVE position for kneeling
mode Indicator (9) to function.
Winch (10)—Indicates that the winch
control system is activated.
NOTE: The blackout switch must be in the STOP
LIGHT or SERVICE DRIVE position for winch
indicator (10) to function.
Self-Deploy Mode (11)—Indicates that the
suspension is active and the machine is in SELF-
DEPLOY mode.
NOTE: The blackout switch must be in the STOP
LIGHT or SERVICE DRIVE position for self-deploy
mode indicator (11) to function.
