TM 9-2350-222-20-1-4
MECHANICAL TRACK ADJUSTING LINK REPAIR (Sheet 3 of 3)
Using hammer and center punch, stake bearing
3.
(B) into link (A) in three places (both sides).
Install bolt (C) and new lockwasher (D) at other
4.
end of link.
5.
Using 9/16 inch wrench, tighten bolt (C) in
place.
Using 7/16 inch wrench, tighten new grease
6.
fitting (E) into position in link (A).
NOTE
For easy access with grease gun, fitting (E) should be pointing
outward when link (A) is installed to tank.
7.
Using grease gun, squirt grease (Item 36, Appendix D) through fitting (E) to make sure it is not
plugged.
8.
End of Task
TA249132
Change 3
14-62.1