TM 9-2350-222-20-1-4
GREASE ACTUATED TRACK ADJUSTING LINK REPLACEMENT (Sheet 5 of 7)
INSTALLATION:
Put a light coat of grease (Item 36,
1.
Appendix D) on two mounting eyes of
compensating idler arm (A).
Put a light coat of grease on pin
2.
assembly (B).
Using second person, position grease
3.
actuated track adjusting link (C) with
yoke (D) facing down and safety relief
valve (E) facing up as shown.
Using second person, put adjusting link (C)
4.
between two eyes of compensating idler
arm (A).
Aline keyways in pin assembly (B) with
5.
splines in adjusting link bearing (F) and
install pin assembly (B) from hull side to
secure adjusting link (C) to compensating
idler arm (A).
Aline tab on pin assembly (B) with threaded hole in compensating idler arm (A) and install
6.
capscrew (G) and new lockwasher (H). Using 3/4 inch wrench, tighten capscrew (G).
Go on to Sheet 6
TA249137
Change 3
14-62.6
