TM 9-2350-222-20-1-4
MECHANICAL TRACK ADJUSTING LINK REPAIR (Sheet 1 of 3)
TOOLS: 3/4 in. sliding tee
7/16 in. combination box and open end wrench
9/16 in. combination box and open end wrench
Hammer
Center punch
Chisel
Grease gun
Mounted vise
SPECIAL TOOL:
Remover-replacer (Item 14, Chapter 3, Section I)
SUPPLIES: Lube fitting (MS15003-4)
Rags (Item 65, Appendix D)
Grease (Item 36, Appendix D)
Lockwasher (MS35338-46)
REFERENCE: TM 9-2350-222-10
PRELIMINARY PROCEDURES: Disconnect track (TM 9-2350-222-10)
Remove mechanical track adjusting link assembly (page 14-56)
DISASSEMBLY:
1.
Using 7/16 inch wrench, remove grease fitting (A) from link (B).
Using 9/16 inch wrench, remove bolt (C) and lockwasher (D). Throw lockwasher (D) away.
2.
Go on to Sheet `2
TA249130
Change 3
14-61
