TM 9-2350-222-20-1-4
HUB ASSEMBLY REPLACEMENT (Sheet 3 of 7)
13
Position remover-replacer (Item 15, Chapter 3,
Section 1) onto inner edge of outer bearing cup
(W) in hub (L).
14.
Using hammer, tap handle to drive outer
bearing cup (W) from hub (L).
15.
Repeat steps 13 thru 14 to remove inner
bearing cup (X) from hub (L), using other
remover- replacer tool (Item 16, Chapter 3,
Section I).
CLEANING AND INSPECTION:
1.
2.
Inspect hub and cover plate for cracks or
damage. There should be no cracks.
3.
Minor nicks, scratches, gouges, and pitting are
okay if they are not on machined surfaces.
Go on to Sheet 4
TA141299
Change 1
14-17