TM 9-2350-222-20-1-4
ROADWHEEL SUPPORT HOUSING ASSEMBLY REPAIR AND REPLACEMENT (Sheet 1 of 2)
10 in. adjustable wrench
TOOLS: 1-5/16 in. socket with 3/4 in. drive
Slip joint pliers
Ratchet with 3/4 in. drive
Torque wrench with 3/4 in. drive (0-600 lb-ft)
Hammer
(0-814 N.m)
36 in. extension bar
Drift pin punch
SUPPLIES: Gasket (10911460)
Grease (Item 37, Appendix D)
Sealing compound (Item 25, Appendix D)
Lockwashers (MS35340-52) (9 required)
PERSONNEL: TWO
PRELIMINARY PROCEDURES: Remove roadwheel arm (page 14-2)
Remove torsion bar anchor (page 14-31)
NOTE
There are six support housings on
each side of tank. The procedures
for all six are identical except that
housing
is
not
no.
1
interchangeable.
NOTE
Use jack to support housing
during removal and installation.
REMOVAL:
1.
Using socket with ratchet, remove nine screws
(A) and lockwashers (B) securing roadwheel
support housing (C) to hull. Throw lockwashers
(B) away.
Remove housing (C) and gasket (D) from hull
2.
mounting place. Throw gasket (D) away.
Go on to Sheet 2
TA141304
1 4 - 2 2 Change 1
