TM 9-2350-222-20-1-4
BRAKE CONTROL PEDAL AND BRACKET REPAIR AND REPLACEMENT
(Sheet 5 of 5)
Position control pedal (P) on levers (C) and
9.
Insert two pins (Q).
10.
Using pliers, install two lockpins (R) through
11.
holes in pins (Q).
Place new lockwasher (S) on each of two screws
12.
(T).
Position bracket (E) over locating pin of mount
13.
and aline mounting holes.
Holding bracket (E) slightly raised, tighten rear
14.
screw (J) finger tight.
Insert two screws (T) in front mounting holes
15.
and tighten finger tight.
16. Using 9/16 inch wrench, tighten screw (J) and
two screws (T).
TA140336
End of Task
13-28